ATA ALP 01 GS, Installation, Use And Maintenance Manual

Page: 22 / 44

WARNINGS
The appliance is to be used for washing baking trays, ice cream basins, baking tins, saucepans
and kitchen utensils.
x
Read the instructions carefully before installation, use and maintenance of the appliance.
x
The installation has to be performed by qualified personnel following the manufacturer's
instructions given in the provided manual.
x
The appliance should only be used by trained personnel.
x
In the event of breakdown or malfunction, switch off the appliance and seek help exclusively
from an authorized technical assistance centre.
x
Only use genuine spare parts; otherwise no liability is assumed by the manufacturer.
INSTALLATION
Noise level <70 dB (A)
WATER CONNECTION
The appliance installation requires the connection of hydraulic flexible pipes, supplied together with
the appliance and in particular:
x
3/4" water supply hose GAS;
x
Ø1½ " drain hose.
Connect the drain hose of the appliance to a suitable drain waste system, through a siphon on the
floor near the appliance itself. Connect the filling pipe with a 3/4" GAS water supply protected by
an interception valve.
Before proceeding with the water connection, check the following conditions:
x
The water supply pressure, measured with open valve, has to vary between 1 and 4 bars. If the
water supply pressure is lower than 1 bar, install a booster pump with delivery of 30 litres/min; if
it is higher than 4 bars, a pressure reducer set at 4 bars maximum has to be installed.
x
The water hardness has to be between 8° and 14° F (0,8 - 1,4 mmol/l). If the water is harder,
install a water softener suitable for the water quantity used by the appliance containing 16 litres
of resin at least.
x
If the appliance is not provided with a built-in detergent dispenser, it is possible to install one
outside the appliance by qualified personnel. The pipe coming out of the dispenser has to be
connected to the appropriate stainless steel connection Ø 6 mm, which is welded on the frontal
part of the tank, as in the pictures below.
ALP 01 S - 01 GS
ALP 02 S -02 GS
22