ASV VT-70, Operation And Maintenance Manual

Page: 96 / 98

7 MAINTENANCE
94
VT-70 High Output US ISO O&M
0404-853 2019-09
7.23 Jacking Procedure
Jacking the machine should only be done from beneath the machine with a jack
of the proper capacity.
To safely lift your machine:
1. Remove any attachments that may be fastened to the machine.
2. Install the lift arm brace as instructed in section 5.14.
3. Once the lift arms are secured, carefully exit the machine.
4. Roll or slide your jack under the front of the machine and center the lifting
pad
beneath the center of the front torsion axle .
5. Once in place, jack the machine upward making sure it remains stable
until it has reached sufficient height to install suitable mechanical supports
beneath the machine.
6. Slide the mechanical supports into place making sure they are positioned
beneath the torsion axles only and spaced in such a manner that the
machine will be stable when its weight rests solely on the supports.
7. Once the supports are in place, slowly lower the machine onto them and
then remove the jack.
Repeat steps 4-7 at the rear of the machine should both ends of the machine
need to be off of the ground for service.
Lift the machine straight up in a slow and careful manner (under the torsion axles
only). Lower it this same way making sure all persons in the area are clear of the
machine and its expected path.
Note: When using a jack to lift the machine, place the jack beneath the torsion
axles only. Lifting at any other point may cause machine damage.
NOTICE
When lifting attachments or components, use caution. Attach straps or
chains securely and in such a way that they evenly distribute the weight
of the item to be lifted, ensuring a balanced load. Stay clear of expected travel
path.