ASV RC30, Service & Repair Manual

Page: 80 / 117

Rubber Track Loader
12. Undercarriage Disassembly and Assembly
12-3
Figure 12-7 12-010
7. With wheels removed, inspect the axle for wear
or damage.
Wheel Installation
Figure 12-8 12-049
1. Mount the wheel on the shaft. In this illustration
the front outside wheel is shown, but the proce-
dure is the same for all wheels
Figure 12-9 12-016
2. Install the wheel nut on the shaft.
Figure 12-10 12-051
3. Insert the o-ring into the wheel, seating it against
the outside bearing race. Make sure there is
adequate grease inside the bearing, but remove
excess grease in the area of the o-ring. Install
the wheel cap and snap-ring. Make sure the
snap-ring is fully seated in its grove.
Sprocket Roller Removal and
Installation
The tools required for sprocket roller removal and
installation are listed in Table 12-2. Use manufac-
turer-recommended tools whenever possible.
Table 12-2
Required Tools
Socket Wrench
Combination Wrench
Note: The rollers should be inspected every 25 hours for
rotation and wear-through. The rollers on the drive
sprocket are easily replaceable. The track DOES NOT
need to be removed to replace these rollers.
Roller
Steel Pin
Drive Sprocket
Sprocket
Roller Bolt
Track
Tensioner
Bolt
Motor
Mount
Sprocket
https://www.tractormanualpdf.info/