ASUSTOR NAS Memory Installation Guide
Page 6 of 9
Diagonally slide the new memory module into slot No.1 (as shown in the graphic below)
making sure that the memory module’s connectors are fully inserted into the slot.
Using two fingers, carefully push down and then back on the memory module until it
clicks into place. You should be able to hear an audible “click”.
When installing two memory modules, follow the steps outlined below.
Locate the two pre-installed memory modules as indicated in the graphic below.
For both memory modules, pull back the black protective covering, and then release
the ejector clips by gently pulling them out to the sides. Remove the memory
modules.
