Asus TS300-E4, User Manual

Page: 90 / 224

Chapter 4: Motherboard information 4-20
13. Auxiliary panel connector (20-pin AUX_PANEL1)
This connector is for additional front panel features including front panel
SMB, locator LED and switch, chassis intrusion, and LAN LEDs.
1. Front Panel SMBus (6-1 pin)
These leads connect the front panel SMBus cable.
2. LAN link activity LED (2-pin LAN1_LINKACTLED and 2-pin LAN1_
LINKACTLED
Both of the 2-pin connectors are for the LAN1 and LAN2 Activity LED.
Connect the LAN Activity LED cable to this connector.
This LED blinks during a network activity and is always lit when linked.
3. Chassis Intrusion connector (4-1pin CASEOPEN)
This lead is for a chassis with an intrusion detection feature. This
requires an external detection mechanism such as a chassis intrusion
sensor or microswitch. When you remove any chassis component, the
sensor triggers and sends a high-level signal to this lead to record a
chassis intrusion event. If you like to disable this feature, please place
one jumper cap over the CASEOPEN and GND leads.
4. Locator LED (2-pin LOCATORLED1 and 2-pin LOCATORLED2)
Both of the 2-pin connector is for the Locator LED 1 and LED 2.
Connect the Locator LED cable to this 2-pin connector.
This LED lights up when the Locator button is pressed.
5. Locator Button/Switch (2-pin LOCATORBTN)
This connector is for the locator button. This button queries the state of
the system locator.
P5M2
®
P5M2 Auxiliary Panel Connector
AUX_PA NEL1
I2C_4_D
AT
A#
LOC
AT
+5VSB
LOC
AT
ORLED1-
LAN1_LINK
LOC
AT
ORBTN#
LAN1_AC
T
GN
D
+5VS
B
I2C_4_CLK# GND
GN
D
LAN2_AC
T
LOC
AT
ORLED2-
LAN2_LINK
LOC
AT
CASEOPEN
PIN1
NC
1 2 2
5 4 3 4