2-42
Chapter 2: Hardware information
2.8.4
Installing Fusion Block System accessory
Install your watercooling system to the motherboard using the bundled accessories
to obtain the best thermal solution.
Package contents
1
2
For watercooling system with 3/8” ID tubes
1. Loosen the screw of a 1/2” ID tube clamp and fit the tube into the clamp.
2. Connect the tube to the waterblock and tighten the screw of the clamp using
a screwdriver.
3. Repeat Step 1 and 2 for another tube. Make sure that both tubes are well
connected to prevent leak, and then fill the coolant into the reservoir.
3/8” ID tubes x 2
1/2” to 3/8” ID fittings x 2 10mm to 3/8” ID fittings x 2
3/4” ID tube clamps x 2
1/2” ID tube clamps x 6
Summary of Contents for Rampage Extreme - Motherboard - ATX
Page 1: ...Motherboard Rampage Extreme ...
Page 16: ...xvi ...
Page 128: ...3 48 Chapter 3 BIOS setup ...
