2.
IDE connector (40-1 pin PRI_IDE)
The onboard IDE connector is for the Ultra DMA 100/66/33 signal cable. There are
three connectors on each Ultra DMA 100/66/33 signal cable: blue, black, and gray.
Connect the blue connector to the motherboard’s IDE connector, then select one of the
following modes to configure your device.
P5KPL-AM IN
PRI_IDE
NOTE:
Orient the red markings
on the IDE ribbon cable to PIN 1.
PIN1
P5KPL-AM IN IDE connector
Driver Jumper setting
Mode of device(s)
Cable connector
Single device
Cable-Selected or Master
-
Black
Two devices
Cable-Select
Master
Black
Slave
Gray
Master
Master
Black or gray
Slave
Slave
• Pin 20 on the IDE connector is removed to match the covered hole on the Ultra DMA
cable connector. This prevents incorrect insertion when you connect the IDE cable.
• Use the 80-conductor IDE cable for Ultra DMA 133/100/66 IDE devices.
If any device jumper is set as
“Cable-Select,” ensure that all other
device jumpers have the same
setting.
3.
USB connectors (10-1 pin USB56, USB78)
These connectors are for USB 2.0 ports. Connect the USB module cable to any of
these connectors, then install the module to a slot opening at the back of the system
chassis. These USB connectors comply with USB 2.0 specification that supports up to
480 Mbps connection speed.
P5KPL-AM IN
P5KPL-AM IN USB2.0 connectors
PIN 1
USB+5V
USB_P8
-
USB_P8
+
GND
NC
USB+5V
USB_P7
-
USB_P7
+
GND
USB78
PIN 1
USB+5V
USB_P6
-
USB_P6
+
GND
NC
USB+5V
USB_P5
-
USB_P5
+
GND
USB56
Never connect a 1394
cable to the USB
connectors. Doing so will
damage the motherboard!
The USB module cable
is purchased separately.
1-11
ASUS P5KPL-AM IN
Summary of Contents for P5KPL-AM IN
Page 1: ...Motherboard P5KPL AM IN ...
