Asus ASMB2, User Manual

Page: 25 / 62

A S U S A S M B 2 A S U S A S M B 2
A S U S A S M B 2 A S U S A S M B 2
A S U S A S M B 2 2 - 1 1 2 - 1 1
2 - 1 1 2 - 1 1
2 - 1 1
ASMC Help Menu options ASMC Help Menu options
ASMC Help Menu options ASMC Help Menu options ASMC Help Menu options
O p t i o n s O p t i o n s
O p t i o n s O p t i o n s
O p t i o n s D e s c r i p t i o n D e s c r i p t i o n
D e s c r i p t i o n D e s c r i p t i o n
D e s c r i p t i o n
-flash -load filename Update the ASMB2 firmware
-sdr -save filename Save the SDR data to file
-sdr -load filename Update the SDR data from file
-kcs[smic/bt/pci_smic] NetFn command data....
Send IPMI command
-bmc_ip [ip_addr] Write the BMC IP address
(e.g., bmc_ip 10.10.10.20)
--pet_ip_mac [ip_addr] [mac_addr] Write the PET destination IP and MAC
(e.g., pet_ip_mac 10.10.10.20 010203040506)
addresses
-adm_name new_name_string Change the administration name
-user_name new_name_string Change the user name
-adm_password new_adm_password Change the administration password
-user_password new_user_password Change the user password
-init_asmb2 Initialize ASMB2
-sol_baud [baud rate] Set the communication Baud rate
(e.g., sol_baud 57600)
-bmc_info Displays the BMC and PET IP and MAC
addresses
2.5.3 2.5.3 2.5.3 2.5.3 2.5.3 Configuring the LAN controller Configuring the LAN controller Configuring the LAN controller Configuring the LAN controller Configuring the LAN controller
Before you can establish connection to the ASMB2 board, you must
configure the LAN port for server management used by the remote server
to connect to the local/central server.
To configure the LAN port of the remote server:
1. On the prompt, type a s m c - i n i t _ a s m b 2 a s m c - i n i t _ a s m b 2 a s m c - i n i t _ a s m b 2 a s m c - i n i t _ a s m b 2 a s m c - i n i t _ a s m b 2, then press <Enter>. The
screen displays the auto-detected information including the system/
motherboard name, and the IPMI2.0 interface. The screen also shows
the status of the ASMB2.
2. Shut down the remote server, then disconnect the power plug from the
electrical socket to initialize the ASMB2.
3. Restart the remote server from the support CD.
4. Run the ASMC utility from the support CD following the instructions in
the previous section.