2) Edit the SINK data among the program data.
SINK Setup [F1]
→
[Rotary key] or F2 or F3 to select item to be set
→
Switch to check button ON
Details of the items are listed below.
Item
Details
Repeater
For using the VA-1809 as a repeater.
Receiver
For using the VA-1809 as a receiver (simple monitor).
DVI
For using the VA-1809 as a DVI monitor (repeater).
HDMI
For using the VA-1809 as an HDMI monitor (repeater).
HDCP ON
For using the VA-1809 as a monitor (repeater) that supports HDCP.
HDCP OFF
For using the VA-1809 as a monitor (repeater) that does not support
HDCP.
* When using the VA-1809 as a receiver, no signals will be output from the
HDMI connector or COAX OUT connector.
* When using the VA-1809 as DVI monitor (repeater), no sound can be input.
* If HDMI pictures using HDCP are input when HDCP is supported, they cannot
be output from the VGA output connector.
* To save the program data on a card or as an internal pattern, move to SAVE
MENU.
* To read the data saved, the execution mode must be set to PROGRAM MODE.
Refer to page
???
.
* When reading saved data, refer to page
???
.
7.1.1.3 Creating groups
The VA-1809 enables the data in up to ten program to be selected from among all
the program data and executed.
Proceed as instructed in the steps below.
TOP
→
PROGRAMEXE[PROGRAM]
→
LISTEdit[F1]
(1) Select the numbers of the programs in the group to be executed.
[Rotary key] to select numbers of programs to be executed
→
[ENTER] to enter the selection
----------------------------
選択画面表示
-------------------------------------
(2) Select the program data to be executed.
[Rotary key] to select program data
→
[ENTER] to enter selection
----------------------------
選択画面表示
-------------------------------------
21
