Details of the modes are given below.
Item
Details
PROGRAM Mode
All the programs are executed.
PROGRAM GROUP
Mode
Only the programs selected by PROGRAM GROUP EDIT
are executed.
* For details on PROGRAM GROUP EDIT, refer to
???
on page
???
.
7.3.3 Adjusting the speaker volume
Use the rotary key to adjust the volume of the VA-1809's built-in speaker. The
volume of the sound delivered from the HDMI output and COAX OUT
connectors cannot be adjusted.
PAGE 2 [F3]
→
[F1 or F2] to select SPEAKER VOLUME
→
[ENTER] to enter selection
→
[Rotary key] to adjust SPEAKER VOLUME value.
* Either 2 channels (1 stream) of a maximum of 8 channels (4 streams) with
frequencies from 32 to 96 kHz for linear PCM only or both channels of 2
channels with frequencies from 176.4 to 192 kHz can be output as the sound.
7.3.4 Setting the hot plug button
PAGE 2 [F3]
→
[F1 or F2] to select HOTPLUG MODE
→
[ENTER] to enter selection
The settings available when the HOTPLUG button is pressed can be performed.
Item
Details
AUTO MODE
Low changes to high when the button is pressed once.
Any time from 10ms to 200ms can be selected at the low
period. Use the rotary key to select it.
* This length also applies to changes in the hotplug signals
when other processes are undertaken.
MANUAL MODE
The level is reversed when the button is pressed once.
* In MANUAL MODE, the value selected using MANUAL is retained even
when the hotplug signal must be changed (such as while EDID is being
changed) during normal operation. For this reason, the mode should normally
be kept at AUTO MODE.
27
