Fitting the plug-in card
Operating Instructions V 112 -
Version 07-2009A
Page 6
Fitting an output channel filter
In order to improve the signal-to-noise ratio, you have the option to
fit a selective output channel filter of type V-KF.. to the two outputs
of the V 112 (see "Technical Data" section).
Follow the steps below to fit the output channel filter in the card:
A
UFGABE
1.
Plug a V-KF.. type filter into the slot provided for it on the top of
the card. Make sure that the filter is facing the direction shown
in the figure on the left.
E
RGEBNIS
:
You have now installed the output channel filter.
You need to use the HE programming software or the KC3 program-
ming unit to enable the output channel filter. (Please see the sec-
tions "Programming with the HE programming software" and
"Programming with the KC3").
Fitting the plug-in card
V
ORBEREITUNG
:
You need to open the base unit before you can insert the plug-in
card. The operating instructions for the base unit describe how to
open the base unit. Once you have removed the case cover from
the base unit, you can start fitting the plug-in card.
Figure 4 shows the plug-in card once it is fitted.
[1] Contact strip connector
[2] IEC male connector
Figure 4: Plug-in card fitted in base unit
Summary of Contents for V 112
Page 1: ...Version 07 2009A ...
