Page 15
Programming with the KC 3
Operating Instructions V 112 -
Version 07-2009A
You can enter the parameters directly via the keypad or alter preset
parameters incrementally by pressing the
and
cursor buttons.
Once you have entered a parameter value, you should save it im-
mediately by pressing the
OK - Store
button. The values are then
written to the card.
HINWEIS
:
Numerical values must be entered in full. You
risk losing data through power failure until settings have been
saved!
Once you have made all your settings, you can check operation at
the output of the head end.
The following section explains how to configure the plug-in card in
detail:
Setting the base-unit bus address
If several base units are connected together, you must make sure
that all connected base units are set to different bus addresses in
order to avoid conflicts on the ASTRO bus. The base units are de-
livered with the address preset to 241.
Follow the steps below to set the bus address for the base unit:
A
UFGABE
1.
After plugging in the connector from the KC3, use the
or
cursor button to access the menu for setting the base unit
parameters.
2.
Select line 3 by pressing cursor button
or
until the cursor
sits in line 3.
3.
The value for the bus address can lie between 001 and 020, or
equal 241. Press cursor button
or
until the bus address
you require is displayed (see left).
4.
Press the
OK / Store
button to save the setting.
E
RGEBNIS
:
You have now set the bus address of the base unit.
Summary of Contents for V 112
Page 1: ...Version 07 2009A ...
