4 Installation
4.1 Setup
1. Remove all packaging material around melt unit.
2. Carefully lift melt unit out of box.
3. Unpack the binder containing product manuals, electrical
schematic, warranty information and flow control valve hex
wrench. Retain binder for future reference.
4. Unscrew 4 screws from plywood board base; remove and
discard plywood.
5. Carefully uncoil hoses from around melt unit and remove
protective wrap from applicators. Inspect all packing material
for separately wrapped items.
6. Position melt unit for easy access to control panel and
convenient servicing.
7. Level mounting surface to prevent warping of melt unit and to
avoid misalignment of the pump and motor shaft.
8. Using the base mounting holes, bolt melt unit down to a
durable mounting surface in accordance with dimensions in
illustrations in Section 3.6 to prevent accidental upset and
possible injury.
9. Tighten all screws before startup and after melt unit
experiences excessive vibration.
8
LS10 and LS20 19600-121
Copyright 2010 Astro Packaging
