Operation
900005-00, 10/2015
Innovative Hearth Products
Envy™ Direct-Vent Gas Fireplaces
68
REPLACING A DAMAGED BARRIER
• If the barrier becomes damaged, the barrier shall
be replaced with the manufacturer’s barrier for this
appliance.
• For use with barrier(s) Part No(s). J7407 (35” Models),
J7408 (40” Models), and J7409 (45” Models). Follow
installation instructions.
Removing the damaged Barrier
1.
Make sure the unit is OFF and COLD.
2.
Remove the Barrier in Clean Face Surround from the
front of the unit by gripping both sides firmly, then
lifting, and swinging out from the top.
3.
Remove the three Phillips head screws from the trim
piece attaching the bottom of the Clean Face Surround
to the Barrier.
4.
Remove the 5/16ths inch hex head screws attaching the
Barrier to the Clean Face Surround; three (3) from the
top and three (3) from both the left and right side.
5.
Remove the damaged Barrier by sliding Barrier out
through the bottom of the Clean Face Surround.
NOTE:
Pilot holes are not provided. Drill pilot holes
manually.
Installing the new listed Barrier
6.
Push the replacement Barrier into the Clean Face
Surround from the bottom, until the Barrier seats to the
top surround piece.
7.
Replace the three screws in the top of the Barrier
removed in step 3.
8.
Replace all the screws removed in step 4.
9.
Reinstall the Barrier in Clean Face Surround to the front
of the unit by easing it over and onto the front.
Envy Barrier in Drawing 609806-00 Clean-Face Frame Surround
BARRIER
BARRIER
Barrier in Clean-Face Surround
Barrier in Clean-Face Surround
Barrier in Clean
Face Surround
