Astria.us.com
126733-01H
22
GAS CONTROL MODULE SYSTEM
The module has 2 special features built into the system.
CONTINUOUS PILOT FEATURE
This allows the change from a spark to pilot system to a standing
pilot system.
1. There is a switch located on the right side of the module that
reads CONTINUOUS PILOT ON/OFF. This switch selects the pilot's
mode of operation
(
Figure 35
).
2. When the continuous pilot switch is in the OFF position and the
appliance rocker switch is turned ON, the pilot will spark and
light. When the appliance rocker switch is turned OFF, the pilot
will shut OFF when the main burner shuts OFF.
3. When the continuous pilot switch is in the ON position and the
appliance rocker switch is turned ON, the pilot will spark and
light. When the appliance rocker switch is turned OFF, the pilot
will stay ON when the main burner shuts OFF.
4. The continuous pilot mode can also be activated by the Remote
Control.
REMOTE CONTROL FEATURE
The module has a built in remote control receiver that allows the
user to program the remote transmitter at any time during or after
the installation of the burner.
1. There is a switch located on the right side of the module that
reads REMOTE/OFF
(
Figure 36
).
2. When the remote/off switch is in the OFF position, the burner
will operate from the rocker switch or wall switch connected
to the two BROWN wires on the module.
3. When the remote/off is in the REMOTE position the burner will
operate from the Remote Control transmitter.
NOTE:
The module must be programmed to the Remote Control
transmitter.
• To program the module (make sure the system has power),
locate the learn button
(
Figure 36
)
on the module. Press and
release the learn button. There will be a beep sound from the
module. Then press any button on the remote transmitter.
Once the module's internal receiver accepts the transmitter
code, there will be a series of confirming beeps.
• The remote system is ready for use.
BATTERY BACK-UP
This fireplace is equipped with a battery back-up. If the power was
to go out on the fireplace, the battery back-up allows the fireplace to
remain operational. Make sure to periodically check the condition of
the four AA batteries used for the battery back-up.
REPLACING BATTERIES IN HAND-HELD REMOTE CONTROL AND
AC BATTERY BACKUP
Replacing Batteries in AC Battery Backup
1. Remove bottom access door.
2. Remove battery pack from metal housing.
3. Remove screw and battery pack cover.
4. Remove existing batteries. Install 4 AA batteries into battery pack
following positive and negative directions.
5. Replace battery pack cover and screw.
6. Insert battery pack back into metal housing.
7. Replace bottom access door.
Installing Batteries in Remote Control Unit
1. Remove battery cover on back of remote control unit.
2. Remove battery.
3. Install 1 A23/12V battery following positive and negative direc-
tions.
4. Replace battery cover onto remote control unit.
WARNING
Electrical Grounding Instructions
This appliance is equipped with a three-prong (ground-
ing) plug for your protection against shock hazard and
should be plugged directly into a properly grounded
three-prong receptacle. Do not cut or remove the
grounding prong from this plug.
FIREPLACE INSTALLATION
Continued
Figure 35 - Gas Module Right Side
Figure 36 - Gas Module Left Side
ADJ.
Remote/Off Switch.
“S” Pilot Connection
“I” Pilot Connection
Learn Button
AUX Connection
Continuous Pilot
Off/On Switch
f i r e - p a r t s . c o m
