Astralpool PRO ELYO INVERBOOST NN, User And Service Manual

Page: 23 / 57

- 30 -
6.6 Electrical connection
The power supply for the heat pump must come, preferably, from an exclusive circuit with regulatory protection
components (30mA differential protection) and a magneto-thermal switch.
- The electrical installation must be carried out by a specialized professional (electrician) in accordance with the
standards and regulations in force in the country of installation.
- The heat pump circuit must be connected to a safety earth circuit at the terminal block.
- The cables must be properly installed to prevent interference.
- The pump is intended for connection to a general power supply with earth connection.
- Section of the cable; This section is indicative and should be checked and adapted according to the needs and
conditions of use.
- The tolerance of acceptable voltage variation is +/- 10% during operation.
The connections must be dimensioned according to the power of the device and the state of installation.
Models Circuit breaker
Maximum length of the wire
2,5 mm² 4 mm² 6 mm² 10 mm²
PROELYXP07i 7 A 84 m 135 m 200 m 335 m
PROELYXP09i 9 A
57 m 90 m 130 m 225 m
PROELYXP11i 11A
PROELYXP14i 14 A 43 m 68 m 100 m 170 m
PROELYXP16i 16 A 34 m 54 m 80 m 135 m
PROELYXP20i 20 A 29 m 45 m 66 m 110 m
PROELYXP26i 26 A 135 m 210 m 315 m 525 m
PROELYXP30i 35 A 21 m 34 m 49 m 84 m
PRO ELYO INVERBOOST NN 26T 9 A 57 m 90 m 130 m 225 m
PRO ELYO INVERBOOST NN 35 34 A 21 m 34 m 49 m 84 m
PRO ELYO INVERBOOST NN 35T 13 A - 27 m 39 m 68 m
These values are given as a guideline, only an authorized electrician can determine the values
corresponding to your installation.
The electric cable must be equipped with a ground connection and with a circuit breaker with
differential
30mA.
6. 6. 6. Electrical Electrical Electrical Wiring Wiring Wiring