USER manual
56
of
260
6.6
Dispensing of the coffee
6.6.1 AL version
•
Put the coffee cup under
the dispensing spout
•
pull the lever all the way
down;
•
wait for the short coffee
pre-infusion time (3÷5
seconds);
•
lift the lever until some
resistance is felt, then
release it;
•
wait until coffee delivery
is complete.
Never perform the above actions without coffee in the filter or
without the filter holder attached to the delivery group. The
rapid upward movement of the lever may cause damage to the
appliance, individuals or property.
Delivery time deepens on grinding and the amount of coffee in
the filter holder.
6.6.2 AEP version
•
Put the coffee cup under the
dispensing spout
•
Press the desired delivery
switch. The delivery will begin,
and it can be stopped using the
same switch once the desired
amount of coffee is obtained
in the cup.
6.6.3 SAE - DISPLAY version
PROGRAMMING
The machine is programmed
by default. Should coffee doses
need to be modified, proceed as
follows:
•
Always programme the right-
hand push-button panel first.
In this way all push-button pan-
els get programmed automati-
cally. If necessary programme all
the others subsequently;
•
Position the cup under the dis-
pensing spout;
•
Press button
STOP
PROG.
for at least 5
seconds until all leds of the dose
buttons are lit;
•
Press the wanted dose button,
for example
STOP
PROG.
;
•
to confirm the dose, press but-
ton
STOP
PROG.
again, or button
STOP
PROG.
;
•
repeat this operation for the
other dose buttons;
•
on concluding the programming, press button
STOP
PROG.
until all leds of the push-button
panel are switched off.
The programming of every dose must be carried out with ground
coffee and not with previously used coffee dregs.
STOP
PROG.
STOP
PROG.
STOP
PROG.
