5
INSTALLATION
The underwater light kit consists of the following components:
•
Underwater Light METEOR LSR0640
•
4 x fixing screw 5.5x50 with wallplugs
•
1 x set of washer, ribbed-washer and M6 self-locking nut for bonding
•
Operating Instructions with Declaration of Conformity and Warranty conditions
The METEOR LSR0640 has to be installed on a flat surface on the pool wall under water line.
Do not try to install the underwater pool light while the pool is filled with water.
When the installation is finished briefly test the underwater light prior to fill the pool with water.
The installation have to be realized by a qualified personnel.
Wall
Screw 5.5X50
Sealing grooves (2X)
Sealing
Bonding
Note:
•
Avoid using the underwater pool light out of the water – submerge before lighting.
Wall preparation
To fix the underwater pool light with screws 5.5x50 the diameter of holes drilled into the wall has to
be 8mm/0.32’’.
Sealing
Before inserting the cable with gland through the hole the sealant has to be used into the grooves,
around the four fixing holes and around the gland in the rear surface of the underwater pool light.
The sealant can be on silicon basis but the best solution is MS polymer sealant.
Fixing
The underwater light has to be fixed with four screws 5.5x50 with wallplugs.
Note:
•
Do not overtighten the screws as this can result in underwater pool light damage.
