ASTEL LIGHTING METEOR LSR0640, Operating Instructions Manual

Page: 7 / 12

7
CONTROLS
Single-color cool white (W), warm white (WW), blue (B) or green (G) models
Remote control can be used to turn-on and turn-off the underwater pool light.
Multi-color RGB (M), WGB (WM), RGBW (MW) models:
Remote control has to be used to turn-on and turn-off the underwater pool light and to control the
mode of lighting and luminosity.
The multi-color underwater pool light can be controlled by using the momentary-switch.
When the light is turned-off the color or mode of lighting can be changed sequentially by pressing
the momentary switch for 2 seconds:
RGB (M)
Sequence of lighting
WGB (WM)
Sequence of lighting
RGBW (MW)
Sequence of lighting
Custom Color Custom Color Custom Color
Full RGB Full WGB Full RGBW
Cool White Cool White Neutral White
Bluish White Bluish White White
Red White Red
Green Green Green
Blue Blue Blue
Rainbow Color Spectrum Color Spectrum White Color Spectrum
Custom White Color
(Rainbow) Color Spectrum
Turning on /off
Press the momentary-switch shortly.
Changing the color or mode of lighting
When the light is turned-off press the momentary-switch for 2 seconds.
Setting the Custom Color
At the selected (Rainbow) Color Spectrum mode press the momentary-switch shortly to turn the light
off. After that press the momentary-switch for 5 seconds or until the light is switched to the selected
color and then the Custom Color is set and selected.
Dimming
When the light is turned-on press the momentary-switch until the desired illumination is achieved. By
another pressing of the momentary-switch the luminosity will increase to the maximum illumination.
Set default
Press the momentary switch for min. 40 seconds or until the light is turned off.
Synchronization
When more than one multi-color underwater pool light is connected to the system the optional
Synchronization Unit LSU08 is recommended to synchronize the colors of lighting at the (Rainbow)
Color Spectrum mode of lighting. On the other case the colors of all installed lights would not be the
same after few minutes or hours of operation in the (Rainbow) Color Spectrum mode.
If the multi-color light is used only with one of the fixed color of lighting the synchronization is not
necessary.