6
Bonding
The bonding of the underwater pool light is realized by using a pre-tinned green wire with a yellow
stripe a minimum of 8 AWG (8.36 mm
2
). The wire has to be connected to the rear side of underwater
pool light by the help of prepared fixing terminal M6 and optional cable lug fixed by included set of
nut, washer and ribbed-washer, signed by bonding label.
Note:
•
Bonding is mandatory ONLY when the underwater pool light is mounted using the
Concrete Pool Niche LCPN0640 or LCFN0640
Connection
The power supply has to be connected through the main switch (not included) with correct polarity
and protected by a fuse (not included). The power supply voltage has to be from 10 - 30Vdc.
Note:
•
The power supply has to be switched off before installation.
The underwater light has to be connected as described in the table below:
METEOR LSR0640
wire color
FUNCTION
Red
+ DC Power Supply
Black
GND Power Supply
Orange
+ Control
Brown
GND Control
Remote control and network connection
Single-color cool white (W), warm white (WW), blue (B) or green (G) models
To remotely turn-on and turn-off the underwater pool light the simple switch (not included) can be
used and connected to the CONTROL wires by a 2-pole signal cable (not included).
Note:
•
If the remote control is not used at single-color models for normal operation the both
CONTROL wires have to be bridged and insulated or connected to the GND.
Multi-color RGB (M), WGB (WM), RGBW (MW) models
To control the mode of lighting the simple momentary-switch (not included) has to be used and
connected to the CONTROL wires by the 2-pole signal cable (not included).
Optional LXU01 interface can be connected to the CONTROL wires by using a 2-pole signal cable
(not included).
