VLM60 User Manual
Parameterization
page 18
ASTECH GmbH
SO1Time
Used to set the time interval for regular output to the programming interface S1.
so1t
ime [n]
n = 1 ... 65535 (unit: ms)
default: 100
If the time interval is set smaller than the
Average
parameter, it must be noted that there is no updated speed
value because the time of
Average
has not yet expired.
SO2FORMAT
For the correct function of the fieldbus interface, the internal communication interface S2 must be
parameterized accordingly. There are predefined switch combinations for this, which are shown in chapter 3.
Nevertheless, the internal communication interface S2 can be parameterized in the same way as the
programming interface S1. Information on this can be found in the
SO1Format
parameter.
so2f
ormat [s]
(s
–
string of ‚switches‘
, max. 42 characters)
default:
v:x:h:6 v:y:h:6 r:h:3 x:h:2
See parameter
SO1Format
.
SO2Interface
For correct function of the fieldbus interface, the internal communication interface S2 must be parameterized
accordingly. Only the baud rate 57600 is permissible.
Nevertheless, the internal communication interface S2 can be parameterized in the same way as the
programming interface S1. Information on this can be found in the SO1Interface parameter.
so2i
nterface
[n] [c] [c] [c]
(n = baud rate, c = protocol, parity, ...)
default: 57600 N D
See parameter
SO1Interface
.
SO2On
Serves to switch on and off the data output on the internal communication interface S2.
so2on
[n]
n = 0 (off), 1 (on)
default: 0
For correct operation of the fieldbus interface, this parameter must be set to 1.
SO2Sync
Serves to set the output update on the internal communication interface S2. It can be set whether the output
is to be synchronized to a selectable time interval (SO2Time command) or when an event occurs at the
switching input (TRIGGER).
so2sy
nc
[n]
n = 0, 1
default: 0
0
Time-synchronous. The update is synchronous to the time interval SO2Time.
1
Trigger synchronous. Updating is synchronous to the clocking at the switching input (TRIGGER).
Both options are permitted for the use of the fieldbus interface. The respective application decides on the
setting.
