Premmia PS Series
41
Replacing the System Cover
1. Lay the unit on its right side and make sure that all internal cables, drives and option
cards are properly installed and that screws are tightened.
2. Place the cover down over the chassis so that the front edge of the cover is about an
inch from the front of the chassis.
3. Slide the cover forward until the flange on the front underside of the cover slides
underneath the flange on the front of the chassis, and the rear tabs on the cover fit in
the slots on the rear of the chassis.
4. Reinstall and tighten the retaining screws at the rear of the chassis.
5. If you are using one, replace the padlock.