Associated Research HYAMP II 5030DT, Operation And Service Manual

Page: 44 / 53

OPERATION
40
The following sections describe the procedures for interconnecting your units. Please
refer to the test method you require for specific cable connection instructions.
A. Common Cable Connections.
First locate the HS-8-11 return cable, identified by its double banana plug connectors.
Connect one end to the RETURN jack on the rear panel of the HypotPLUS II and the
other end to the INTERCONNECT jack on the rear panel of the HYAMP II.
Then locate the cable marked “5030DT-21 COMMON”. Connect the female plug
(the end with the blue tubing) to the signal input receptacle on the rear panel of the
HYAMP II. Then connect the male plug (the end with the black tubing) to the signal
output receptacle on the rear panel of the HypotPLUS II.
B. Test Method Specific Connection.
1. For sequential testing methods use the following cable connection. Locate the cable
marked “5030DT-22 SEQUENTIAL”. Connect the male plug (the end with the blue
tubing) to the signal output receptacle on the rear panel of the HYAMP II. Then
connect the female plug (the end with the black tubing) to the signal input receptacle
on the rear panel of the HypotPLUS II.
2. For simultaneous testing methods use the following cable connection. Locate the
cable marked “5030DT-23 SIMULTANEOUS”. Connect the male plug (the end with
the blue tubing) to the signal output receptacle on the rear panel of the HYAMP II.
Then connect the female plug (the end with the black tubing) to the signal input
receptacle on the rear panel of the HypotPLUS II.
Part Number Description Qty.
HS-8-11 Cable Assembly Return 1
5030DT-21 Cable Assembly R/P Interface COM 1
5030DT-22 Cable Assembly R/P Interface SEQ 1
5030DT-23 Cable Assembly R/P Interface SIM 1
36541 Adapter Box HV, HC Domestic 1
RETURN
INTERCONNECT
( CHASSIS)
OUTPUT INPUT
HypotPLUS II
HYAMP II
REAR PANEL
REAR PANEL
FRONT PANEL
FRONT PANEL
HV
RTN
HC
Device Under Test
N
L
G
OUTPUT INPUT
Basic Test Setup