:: Wheel and Tire Assembly (cont.) - Bag O
:: Body
46
Body :
Your SC10 4x4 FT kit comes with a clear
polycarbonate body. You will need to prep the
body before you paint it. Wash the inside
thoroughly with warm water and liquid
detergent. Dry the body using a clean, soft,
lint-free cloth. Use the supplied window masks
to cover the windows from the INSIDE of the
body (RC bodies are painted from the inside).
Using high quality masking tape, apply tape to
the inside of the body to
create a design. Spray (either rattle can or
airbrush) the paint to the inside of the body
(prefferably dark colors first, lighter colors
last).
NOTE: use ONLY paint that is
recommended for use with
(polycarbonate) plastics. If you don’t, you can
destroy the plastic body!!!!).
After painting, cut the body along the trim
lines.
NOTE: The number plates are located in the
wheel wells of the body. The rear fins are
located behind the bed of the body. Cut these
out before you throw away the scrap pieces.
Remove overspray protectant film. Make sure
to drill or use a body reamer to make the holes
for the body mounts, antenna, and
number plates. Add some stickers, and your
ready to race!
The SC10 4x4 RTR comes with a
pre-painted body. Install the body
and you are ready to go.
9876
SC10 Contender
clear body
number plates
(right/left sides)
(FT ONLY)
9876
SC10 Contender
clear body
rear fin
(FT ONLY)
6288
4-40x1/4
bhcs
6222
Nylon locknuts
4/40/5-40
x10
x10
91148
M4 locknut
w/flange
& knurl
x4
