Row scanning mode 4:
1a) Push the ability switch short (Parameter P5) and Apollo starts to automatically scan the
lines on selected page, the LEDs indicates the active line. All the lines are not necessarily
scanned, controller will skip unused ones. The scanning speed depends on the settings.
1b) When the LEDs representing the desired line is selected, push the switch again. Now the
Apollo start to scan Commands on that selected line.
1c) Push the ability switch third time and Apollo transmits the remote control IR-signal
associated with it and/or possible other additional functions.
2a) Push the ability switch long (Parameter P5) and Apollo starts to automatically scan through
the pages (every Page’s signal light switches on in turn). All the Pages are not necessarily
scanned, controller will skip unused ones. The scanning speed depends on the settings.
2b) When the desired Page LED is lit, push the switch again and Apollo select the Page and
starts to automatically scan the lines within the Page.
2c) When the LEDs representing the desired line is selected, push the switch again. Now the
Apollo start to scan Commands on that selected line.
2d) When the symbol representing the desired function is selected, push the switch again. Now
the current function is accepted and Apollo transmits the remote control IR-signal associated
with it and/or possible other additional functions.
Note. If you keep the switch pressed for long, Admiral-2 continues transmitting the remote control
signal associated with the function until you release the switch. This feature can be utilized in such
functions where the length of the signal transmission is of significance, such as when dimming the
lights, adjusting the volume, adjusting the height of the bed, etc.
5.2. Operation with a dual switch mode
In dual switch option you can use either one dual switch or two separate single switches. The switches
are called SCANNING/STEPPING and ACCEPTANCE switches.
Linear stepping mode 2:
1a) Push the STEPPING switch short (Parameter P5) and Apollo make a step automatically to
the next commands on selected page, the LED indicates the active one. All the commands are
not necessarily stepped, controller will skip unused ones. If you keep the switch down it start to
scan automatically the commands.
1b) When the LED representing the desired command is selected, push the ACCEPTANCE
