PN#
500-10550
Page 15
Rev. D, 12/14
9. PERFORM the following to secure strike plate to the door.
a. APPLY the included thread lock compound to 5/16-18 X 1-3/4” flat head socket screw.
b. INSERT the 5/16-18 X 1-3/4” flat head socket screw through the strike bushing, strike
plate, two (2) neoprene washers, door and into the sex bolt as illustrated.
c. TIGHTEN the screw into sex bolt using a 3/16” hex wrench; and while tightening,
gently TAP the head of sex bolt until the head sits flush with the door using a hammer.
NOTE:
The strike should rock on the neoprene washers for proper function and
optimal holding force.
d. DO NOT OVER-TIGHTEN the assembly; the neoprene washers should not be
compressed.
Assembling the Lock to the Bracket and Adjusting, as Necessary
1. LOOSEN the two screws securing the mounting bracket to the door frame so that the
bracket can move.
2. SLIDE the lock onto the mounting bracket and TEST FIT against the strike plate with the
door closed; SLIDE the lock so that the entire face makes contact with the strike plate.
.
MARK back edge of mounting bracket at each end and REMOVE the lock from the
bracket.
