11
Multi-Point Lock
Installation Instructions
FM7300 Series and BL7300 Series
A8220D 04/20
Copyright © 2020 SARGENT Manufacturing Company. All rights reserved. Reproduction in whole or in
part without the express written permission of SARGENT Manufacturing Company is prohibited.
1-800-727-5477 • www.sargentlock.com
3 Installation
(cont.)
h
Top and Bottom Latch Adjustment (cont.)
Using the supplied 3/32" Allen wrench, rotate the top
or bottom worm gears according to the directions
below (Figure 19). Bolt to strike clearance should
equal 1/16". This sets the bolt projection. (Figure 20)
Note:
Ten (10) turns equals approximately 1/16".
Rotate the top:
counterclockwise
to
project the bolt;
clockwise
to retract
the bolt.
Rotate the bottom:
counterclockwise
to
retract the bolt;
clockwise
to project
the bolt.
Note:
Latches have bottomed
if worm gears click.
Tighten set screws. (Figure 21)
Figure 21
IMPORTANT
Set screws must be fully
tightened after adjustment.
Figure 19
TOP OF DOOR
1/16" Bolt to strike clearance.
1/16" Bolt to strike clearance.
BOTTOM OF DOOR
Worm Gear
Worm Gear
Figure 20
