61
Problems, causes, solutions
EN
Updated information, such as reports relating to additionally executed fire tests can be found at:
www.assaabloy.ch
Problem
Cause
Solution
The door can be pushed
or pulled open by hand
although it should be
locked.
The bolt is not extended when the door is closed.
Flip latch cannot freely engage in the strike plate.
Adjust the door and the position of the strike plate
so that the flip latch engages freely in the strike
plate and door frame and can position itself.
The bolt is not extended when the door is closed.
Locking cylinder jammed.
Check and replace the locking cylinder if necessary.
Check switchover operation using a key.
The bolt is not extended when the door is closed.
The trip latch is not actuated.
Check and, if necessary, correct the rebate gap.
The bolt jumps back out
of the lock immediately
after opening the door.
The trip latch is not retained in position for perma-
nent door release. The door handle was not pressed
down completely.
Press the door handle right down to the end stop.
Door handle cannot be pushed down far enough.
Rebate gap is set too wide.
Check and, if necessary, correct the rebate gap.
The trip latch jams in an actuated position.
Check that the lock has been installed without dis-
tortion and, if necessary, correct the installation.
Problems, causes, solutions
Summary of Contents for MSL 124444PE
