An Actuator can only be assigned to
one
Zone.
This screen will appear once the auto calibration is complete.
Press
Yes
to commence Zone Setup.
No
will take you to the Home page where options of
Open All, Close All
, and
Setup
will be available.
Note: There are a total of 30 Zone names to choose from.
Zone names cannot be customised.
See page 29 for the list of the names.
There are two ways to assign Actuators to zones:
1.
If serial numbers are known
(from page 26):
I
f not proceed to section 2 below.
Use the
arrow
keys to scroll, matching the serial number
on the left with the desired Zone on the right.
Press
Add to Zone
and confirm your selection.
2.
If serial numbers are not known:
Press each
Actuator
button on the left.
The corresponding Actuator will open.
Note: After 5 minutes it will close automatically.
Visually locate this Actuator. Then use the
arrow
keys on the right
to select the desired Zone.
Press
Add to Zone
and confirm your selection.
The window will now close if open.
Note: Pressing the Actuator button again will also close the window.
Repeat either process until all Actuators are allocated to your
desired Zones.
Press
Exit & Save
then
Yes
to save your Zone settings.
SYSTEM SETUP AND CONFIGURATION
Allocating Actuators to Zones:
5
Summary of Contents for Interlock Elevation Window Control System
Page 31: ...31 NOTES...
