CLX3300
Installation Instructions
Cylindrical Lockset
4
FM566 05/21
Copyright © 2021, ASSA ABLOY Access and Egress Hardware Group, Inc. All rights reserved. Reproduction in whole or in
part without the express written permission of ASSA ABLOY Access and Egress Hardware Group, Inc. is prohibited.
For installation assistance contact Corbin Russwin
1-800-543-3658 • [email protected] •www.corbinrusswin.com
10
Timing CLX3352 & CLX3382
1. Remove outside and inside levers. (See Section 9)
2. Adjust internal cams visible from both the outside
and inside lock trim.
2a. Use a slotted screwdriver to rotate each cam
until the driver points are in a 6 and 12 o’clock
position. (See Figure 16)
3. Re-install outside and inside levers.
4. Test both cylinders with key before closing the
door.
To Remove:
Rotate key 45° and hold. Depress lever catch with lever release tool.
9
Lever Removal & Installation
Lever catch
To Remove:
Remove core and tailpiece, using key marked “control.”
Insert slotted screwdriver or lever release tool into cylinder opening and make
contact with lever catch.
Pull lever catch horizontally towards the opposite side of the cylinder opening
and remove lever.
To Install:
Without the core installed, slide the lever on over the lever catch. Confirm the
lever will not pull off. Install core and tailpiece, using key marked “control.”
To Remove:
Depress lever catch with lever release tool, remove
lever.
To Install:
Slide the lever on over the lever catch. Confirm the
lever will not pull off.
a
Standard Cylinder (Figure 12)
b
Interchangable or Removable Core (Figure 13)
c
Plain Lever (Figure 13) & Push/Turn Button (Figure 14)
Control Key
To Install:
With driver points at 6 and 12 (See Figure 16), rotate key 45° in
either direction and slide lever on over the lever catch. Confirm the
lever will not pull off.
Figure 12
Figure 13
Figure 14
Figure 15
View into lock from end of trim
12 o’clock drive point
6 o’clock drive point
Figure 16
