CLX3300
Installation Instructions
Cylindrical Lockset
2
FM566 05/21
Copyright © 2021, ASSA ABLOY Access and Egress Hardware Group, Inc. All rights reserved. Reproduction in whole or in
part without the express written permission of ASSA ABLOY Access and Egress Hardware Group, Inc. is prohibited.
For installation assistance contact Corbin Russwin
1-800-543-3658 • [email protected] •www.corbinrusswin.com
5
Adjust Lock for Door Thickness (if necessary)
6
Install Outside Assembly
To adjust lock to door thickness if other than 1-3/4"
(44mm) refer to Section 5.
Insert outside trim assembly into door from outside
making sure that lockbody hooks latch case and
retractor engages bolt tail(s). See Figure 7.
DO NOT FORCE. (If lockbody does not engage latch
easily, check door preparation for errors.)
Latch bolt tail should be centered in depth of
retractor. If it is not, refer to Section 5 to properly
adjust the lock for door thickness.
Lock is factory preset for 1-3/4
"
(44mm) doors unless specified. To adjust lock to door thickness if other than 1-3/4
"
(44mm):
1. Remove outside trim assembly from the lockbody assembly. The lever, rose, and spring housing will remove as one piece
from the lockbody. See Figure 5.
2. Rotate outside rose liner to adjust lock to fit door thickness, so distance (Dimension A) from inside surface of liner to
centerline of retractor is half the thickness of the door. (See chart and Figure 6.)
3. Reassemble outside trim assembly onto lockbody assembly.
Door Thickness
Dimension A
1-3/4
" (44 mm)
7/8
" (22 mm)
2
" (50 mm)
1
" (25 mm)
2-1/4
" (57 mm)
1-1/8
" (29 mm)
Outside Rose Liner
Outside
Trim
Assembly
Lockbody
Assembly
Centerline of Retractor
Retractor
Figure 5
Figure 6
Dimension A
Figure 7
4
Latch Installation
Install screws (2) #8-32 x 3/4".
Figure 4
