1 1
FLOPPY1
Pin1
Red marking
IDE1
PIN1
IDE2
PIN1
J u m p e r
Setting
Description
PS2_USB_PWR1
Short pin2, pin3 to enable
(see p.6 item 22)
+5VSB (standby) for PS/2 or
USB wake up events.
Note: To 5VSB, it requires 2 Amp and higher standby current provided
by power supply.
Clear CMOS
Description
CLRCMOS1
To clear and reset the system
(see p.6 item 17)
parameters to default setup,
please turn off the computer and
unplug the power cord, then
short the solder points for more
than 3 seconds by using metal
material, e.g., a paper clip.
Note:These solder points allow you to clear the data in CMOS. The data in CMOS
includes system setup information such as system password, date, time,
and system setup parameters.
2.8 Connectors
Connectors are NOT jumpers. DO NOT place jumper caps over
these connectors.
Connector
Figure
Description
FDD connector
(33-pin FLOPPY1)
(see p.6 item 10)
Note: Match the red marking on the floppy ribbon cable with Pin1.
Primary IDE connector (Blue)
Secondary IDE connector (Black)
(39-pin IDE1)
(39-pin IDE2)
(see p.6 item 7)
(see p.6 item 8)
+5V
1_2
+5VSB
2_3
solder points
