1 7
1 7
1 7
1 7
1 7
USB 2.0 Header
HD 8CH I/O provides you
(9-pin USB67)
4 ready-to-use USB 2.0 ports on
(see p.9, No. 19)
the rear panel. If the rear USB
ports are not sufficient, this
USB 2.0 header is available to
support 2 extra USB 2.0 ports.
USB 2.0 Header
HD 8CH I/O provides you
(9-pin USB45)
4 ready-to-use USB 2.0 ports on
(see p.9, No. 20)
the rear panel. If the rear USB
ports are not sufficient, this
USB 2.0 header is available to
support 2 extra USB 2.0 ports.
Infrared Module Header
This header supports an optional
(5-pin IR1)
wireless transmitting and
(see p.9, No. 8)
receiving infrared module.
Internal Audio Connectors
These connectors allow you
(4-pin CD1)
to receive stereo audio input
(CD1: see p.9, No. 27)
from sound sources such as
a CD-ROM, DVD-ROM, TV
tuner card, or MPEG card.
Front Panel Audio Header
This is an interface for the front
(9-pin HD_AUDIO1)
panel audio cable that allows
(see p.9, No. 25)
convenient connection and
control of audio devices.
CD-R
GND
GND
CD-L
CD1
USB_PW
R
USB_PW
R
P+5
P-5
P+4
P-4
G
N
D
G
N
D
D
UMMY
1
USB
_
P
WR
USB
_
P
WR
P
+7
P
-7
P
+
6
P
-
6
GND
GND
D
U
MMY
1
1
I
R
TX
I
RR
X
G
N
D
+5VSB
D
UMMY
J_SENSE
OUT2_L
1
MI
C
_
R
ET
P
R
ESEN
C
E#
G
N
D
OUT2_
R
MI
C
2_
R
MI
C
2_L
OUT_
R
ET
1. High Definition Audio supports Jack Sensing, but the panel wire on the
chassis must support HDA to function correctly. Please follow the
instruction in our manual and chassis manual to install your system.
2. If you use AC’97 audio panel, please install it to the front panel audio
header as below:
A. Connect Mic_IN (MIC) to MIC2_L.
B. Connect Audio_R (RIN) to OUT2_R and Audio_L (LIN) to OUT2_L.
C. MIC_RET and OUT_RET are for HD audio panel only. You don’t
need to connect them for AC’97 audio panel.
D. Enter BIOS Setup Utility. Enter Advanced Settings, and then select
Chipset Configuration. Set the Front Panel Control option from
[Auto] to [Enabled].
E. Enter Windows system. Click the icon on the lower right hand
taskbar to enter Realtek HD Audio Manager. Click “Audio I/O”, select
“Connector Settings”
, choose “Disable front panel jack
detection”, and save the change by clicking “OK”.
