2 6
2 6
2 6
2 6
2 6
Processor Multiplier
This item will show when “Multiplier/Voltage Change” is set to [Manual];
otherwise, it will be hidden. You may set the value from [x4] up to [x25] but
no higher than the value of “Processor Maximum Multiplier”. For example, if
the value of “Processor Maximum Multiplier” is [x11], the actual value of
multiplier will be [x11] even if you set this item to a value higher than [x11].
However, for system stability, it is not recommended to adjust the value of
this item.
Processor Voltage
This item will show when “Multiplier/Voltage Change” is set to [Manual];
otherwise, it will be hidden. You may set the value from [1.550V] down to
[0.800V]. However, for safety and system stability, it is not recommended
to adjust the value of this item.
Memory Clock
This item can be set by the code using [Auto]. You can set one of the
standard values as listed: [133 MHz (DDR266)], [166 MHz (DDR333)],
[200 MHz (DDR400)].
Flexibility Option
The default value of this option is [Disabled]. It will allow better tolerance for
memory compatibility when it is set to [Enabled].
Bank Interleaving
Interleaving allows memory accesses to be spread out over banks on the
same node, or accross nodes, decreasing access contention.
Burst Length
Burst length can be set to 8, 4, or 2 beats.
BIOS SETUP UTILITY
CPU Configuration
Select how to set the
CPU host frequency.
Select Screen
Select Item
+-
Change Option
F1
General Help
F9
Load Defaults
F10
Save and Exit
ESC
Exit
v02.54 (C) Copyright 1985-2003, American Megatrends, Inc.
Advanced
Select Screen
Select Item
+-
Change Option
F1
General Help
F9
Load Defaults
F10
Save and Exit
ESC
Exit
Actual Frequency (MHz)
CPU Host Frequency
[200]
[Auto]
Boot Failure Guard
Spread Spectrum
Cool' n' Quiet
[Enabled]
[Auto]
[
]
Enabled
Processor Maximum Multiplier
Processor Maximum Voltage
x11
1.550 V
Multiplier/Voltage Change
[Manual]
Processor Multiplier
Processor Voltage
Memory Clock
Flexibility Option
Bank Interleaving
Burst Length
CAS Latency (CL)
TRCD
TRAS
[x8]
[1.500V]
[Auto]
[Auto]
[4 Beats]
[Auto]
[Auto]
[Auto]
[Disabled]
CAS Latency (CL)
Use this item to adjust the means of memory accessing. Configuration
options: [Auto], [2.0], [3.0], and [2.5].
