1 9
1 9
1 9
1 9
1 9
2.8
2.8
2.8
2.8
2.8 Serial A
Serial A
Serial A
Serial A
Serial ATTTTTA (SA
A (SA
A (SA
A (SA
A (SATTTTTA) Hard Disks Installation
A) Hard Disks Installation
A) Hard Disks Installation
A) Hard Disks Installation
A) Hard Disks Installation
This motherboard supports Serial ATA (SATA) hard disks and RAID functions
(RAID0, 1, JBOD). This section will guide you to install the SATA hard disks.
STEP 1: Install the SATA hard disks into the drive bays of your chassis.
STEP 2: Connect the SATA power cable to the SATA hard disk.
STEP 3: Connect one end of the SATA data cable to the motherboard’s SATA
connector.
STEP 4: Connect the other end of the SATA data cable to the SATA hard disk.
2.9 Hot Plug and Hot Swap F
2.9 Hot Plug and Hot Swap F
2.9 Hot Plug and Hot Swap F
2.9 Hot Plug and Hot Swap F
2.9 Hot Plug and Hot Swap Functions for SA
unctions for SA
unctions for SA
unctions for SA
unctions for SATTTTTA HDDs
A HDDs
A HDDs
A HDDs
A HDDs
K8VM890
motherboard supports Hot Plug and Hot Swap functions for
SATA Devices.
NOTE
What is Hot Plug Function?
If the SATA HDDs are NOT set for RAID configuration, it is called “Hot
Plug” for the action to insert and remove the SATA HDDs while the system
is still power-on and in working condition.
However, please note that it cannot perform Hot Plug if the OS has been
installed into the SATA HDD.
What is Hot Swap Function?
If SATA HDDs are built as RAID1 then it is called “Hot Swap” for the action
to insert and remove the SATA HDDs while the system is still power-on
and in working condition.
COM Port Header
This COM port header is used
(9-pin COM1)
to support a COM port module.
(see p.9 No. 30)
CCT
S
#1
DD
S
R#1
DDTR#1
RRXD1
DDCD#1
TTXD1
GND
RRT
S
#1
RRI#1
1
