ASROCK K8UPGRADE-VM -, Installation Manual

Page: 8 / 128

8 88
88
ASRock K8Upgrade-VM800 Motherboard
2.2 2.2 2.2 2.2 2.2 Installation of Memory Modules (DIMM) Installation of Memory Modules (DIMM) Installation of Memory Modules (DIMM) Installation of Memory Modules (DIMM) Installation of Memory Modules (DIMM)
K8Upgrade-VM800 motherboard provides two 184-pin DDR (Double Data Rate)
DIMM slots.
Please make sure to disconnect power supply before adding or
removing DIMMs or the system components.
Step 1. Unlock a DIMM slot by pressing the retaining clips outward.
Step 2. Align a DIMM on the slot such that the notch on the DIMM matches the break
on the slot.
The DIMM only fits in one correct orientation. It will cause permanent
damage to the motherboard and the DIMM if you force the DIMM into the
slot at incorrect orientation.
Step 3. Firmly insert the DIMM into the slot until the retaining clips at both ends fully
snap back in place and the DIMM is properly seated.
2.3 2.3
2.3 2.3 2.3
Expansion Slots Expansion Slots
Expansion Slots Expansion Slots Expansion Slots
(Future CPU Port, PCI Slots, AGP Slot, and AMR Slots) (Future CPU Port, PCI Slots, AGP Slot, and AMR Slots) (Future CPU Port, PCI Slots, AGP Slot, and AMR Slots) (Future CPU Port, PCI Slots, AGP Slot, and AMR Slots) (Future CPU Port, PCI Slots, AGP Slot, and AMR Slots)
There are 1 Future CPU Port, 2 PCI slots, 1 AGP slot and 1 AMR slot on K8Upgrade-
VM800 motherboard.
Future CPU Port (Yellow-Colored Port):
Future CPU Port allows you to upgrade your AMD 754-Pin CPU to AMD 939-Pin CPU by
installing an add-on ASRock 939CPU Board into this future CPU Port on K8Upgrade-
VM800 motherboard. Before you upgrade the 754-Pin CPU to the 939-Pin CPU, it is
necessary to adjust the jumper settings for those required jumpers on K8Upgrade-
VM800 motherboard. Please refer to the table below for the correct jumper settings.
EnglishEnglishEnglishEnglishEnglish