ASROCK ALIVEN570SLI-ESATA2, Installation Manual

Page: 20 / 224

2 0 2 0
2 0 2 0 2 0
ASRock ALiveN570SLI-eSATA2 Motherboard
EnglishEnglishEnglishEnglishEnglish
connect the black end
to the IDE devices
connect the blue end
to the motherboard
80-conductor ATA 66/100/133 cable
2.7 Onboard Headers and Connectors 2.7 Onboard Headers and Connectors
2.7 Onboard Headers and Connectors 2.7 Onboard Headers and Connectors
2.7 Onboard Headers and Connectors
Onboard headers and connectors are NOT jumpers. Do NOT place
jumper caps over these headers and connectors. Placing jumper caps
over the headers and connectors will cause permanent damage of the
motherboard!
•
Floppy Connector
(33-pin FLOPPY1)
(see p.2, No. 25)
Note: Make sure the red-striped side of the cable is plugged into Pin1 side of the
connector.
Primary IDE connector (Blue)
(39-pin IDE1, see p.2, No. 9)
Note: Please refer to the instruction of your IDE device vendor for the details.
the red-striped side to Pin1
Serial ATA II Connectors These six Serial ATAII
(SATAII_1 (PORT1.0):
(SATAII) connectors support
see p.2, No. 13)
SATA data cables for internal
(SATAII_2 (PORT1.1):
storage devices. The current
see p.2, No. 18)
SATAII interface allows up to
(SATAII_3 (PORT2.0):
3.0 Gb/s data transfer rate.
see p.2, No. 14)
(SATAII_4 (PORT2.1):
see p.2, No. 17)
(SATAII_5 (PORT3.0):
see p.2, No. 15)
(SATAII_6 (PORT3.1):
see p.2, No. 16)
SATAII_6 (PORT3.1) connector can be used for internal storage de-
vice or be connected to eSATAII connector to support eSATAII device.
Please read “eSATAII Interface Introduction” on page 26 for details
about eSATAII and eSATAII installation procedures.
SA
T
AII_1 (POR
T1.0)
SA
T
AII_3 (POR
T2.0)
SA
T
AII_5 (POR
T3.0)
SA
T
A
II_2 (POR
T1.1)
SA
T
A
II_4 (POR
T2.1)
SA
T
A
II_6 (POR
T3.1)