ASRock Industrial iEP-9010E, User Manual

Page: 4 / 76

13. Never attempt to repair the device, which should only be serviced by qualified technical
personnel using suitable tools.
14. Any unverified component may cause unexpected damage. To ensure correct
installation, always use the components (e.g., screws) provided in the accessory box.
15. This equipment is not suitable for use in locations where children are likely to be
present.
16. The equipment should only be installed in a restricted access area.
17. Restricted Access Location:
The device must be installed only in a server room or computer room where access is:
•
Access can only be gained by service persons or by users who have been instructed
about the reasons for the restrictions applied to the location and about any precautions
that shall be taken.
•
Access is through the use of a tool or lock and key, or other means of security, and is
controlled by the authority responsible for the location.
•
Leave enough clearance (25 inches in the front and 30 inches in the back of the rack) to
allow the front door to be opened completely and to allow for sufficient airflow.
•
This product is for installation merely in a Restricted Access Location.
•
This product is not suitable for use with visual display workplace devices according to §2
of "the German Ordinance for Work with Visual Display Units".
18. The equipment is intended to be supplied by the external power source (UL listed/ IEC
60950-1/ IEC 62368-1 approved) whose output complies with ES1/SELV. To reduce
potential safety issues, only the AC adapter provided with the product, a replacement
AC adapter provided by ASRock Industrial or agency, or an AC adapter purchased as
an accessory from ASRock Industrial or agency should be used with the product.
19. This power adapter (FSP330-AAAN3) is intended to be supplied based on a UL-
certified and suitable for use at an operating/storage temperature of 0 °C (32 °F)~ 40 °C
(104 °F)/ -20 °C (-4 °F)~80 °C (176 °F), and the current output is rated 13.75A. If you
need further assistance, contact ASRock Industrial for additional information.
20. The ambient temperature of the iEP-9010E series: 70 °C (158°F) max.; the ambient
temperature of the iEPF-9010S series: 75 °C (167°F) max.
21. The terminal block is suitable for V+& V-, 3 units for each (16~18AWG) which means
6 units in total. The torque value is 0.69Nm. And use copper conductors only. Kindly
note that must be installed by a skilled person.
22. LAN port must use shielded LAN cable.