Installation and User Manual for Vice
Page 1 (of 7)
HV 515 and 516
Clamping system HV 515 and 516 (
see Fig. 1
):
1.
Base plate
5. Guide rods
2.
Face
6. Head with hole for capstan
28-25mm (1,1“- 0,98“)
3.
Spindle 7.
Retaining
ring
4.
Nut
1.
Foreword
:
Read carefully all instructions of this User Manual, especially sections concerning work safety.
These sections are marked by a warning triangle.
2. Important notice !!
-
the head (6) has an opening for the capstan
∅
25-28mm (1“-5/8“)
-
to ensure safe fixing of the vice, the minimum workbench thickness is
30mm (5/4“)
-
after unpacking, the vice must be cleaned of all preservative grease and rust on the guide rods
-
prior to installation, the HVQ vice must be dismantled into two parts by removing the retaining
ring (7) and subsequent turning the spindle clockwise (CW) until the entire base plate (1) slides off
the guide rods (5)
-
assembly is done by reverse procedure and turning the spindle counter clockwise (CCW). For
centering and inserting the spindle (3) into the nut (4), it is sometimes necessary to use an
assistance tool, for example a screwdriver
-
vice installation is easier when the workbench is turned upside down
-
to ensure correct vice operation it is recommended to lubricate the spindle (3) and guide rods (5)
with oil
once a week
Fig. 1
2
6
3
5
1
4
7
CCW
CW
