Aspirante thermostatic power shower
Fig.
rEMOVING THE COVEr
note:
When you first receive your Aspirante
power shower, the temperature control knob
and cover fixing screws will be packaged
separately within the box. In this instance just
carefully remove the cover and proceed to
‘Plumbing connections’ below.
To remove the cover, first pull off the
temperature control only
(fig.)
– not the flow
control.
This will reveal the maximum temperature stop
(fig.)
. This should be left in position.
note:
If adjustment of the maximum
temperature stop is required, refer to section
’Adjusting the maximum temperature stop’.
Remove the two cover fixing screws – top and
bottom
(fig.8)
.
Carefully lift the cover away from the backplate.
Lay aside the cover and screws until the unit is
fully installed.
note:
When removing the cover for future
maintenance purposes etc. be aware of the lead
connected to the PCB unit. Carefully pull off the
lead from the PCB.
DO nOT let the cover dangle by the lead.
Maximum
temperature
stop
Fig.
Fig.8
