SMC02G/SMC02F/Variants - Product Manual
Figure 3
SMC02 – Inserting the Zone Identification Labels
LABEL
BUTTONS 1-5
•
Do not use any sharp tools, as they can damage the front panel.
•
Do not peel off the plastic cover.
!
!
d. Re-fit the front panel back in place using the 11 off screws removed in step
3.a
.
4.
Ensure that the power supply from the central equipment rack is turned off.
5.
Plug the lead assembly (ASL SMCLEAD-5M or SMCLEAD-20M) into the circular connector at the
bottom of the SMC02 back box.
6.
Fix the SMC02 into its position.
a. If mounting the SMC02 on a desk, fit the SMC02 into the recess, and then fix it using the M6
screws and washers provided.
b. If mounting the SMC02 in a 19” rack, fix the unit into its position in the rack using the M6 screws
and washers provided.
Refer to
Figure 12
for mechanical dimensions and clearance required.
7.
If installing a SMC02F or SMC02FS, fix the fist microphone clip to a suitable adjacent point.
8.
Connect the flying lead assembly to a marshalling box (which is cabled to the central equipment rack
or wall mount Intellevac ACU).
See connection details in Section “
4 Connections
” (page
23
).
9.
Power the unit on from the central equipment rack.
10.
Commission the microphone as described in Section “
5 Commissioning the SMC02
” (page
31
).
Issue: 02 complete, approved
Page 22 of 60
Summary of Contents for SMC02
Page 60: ......