18
Instruction Manual
AP01 : WJ32
How to Use SPM Function
SPM_LOG Mode
Log data set
to be deleted
データの消去
確認
Confirmation of whether or not the
entire log data should be deleted
Number of data in
memory
Number of data in
memory
Initial display of
SPM_LOG mode
B
B
B
Press for
more than
2 seconds.
Keep the button
pressed for 2 more
seconds or longer.
Keep the button
pressed for 2 more
seconds or longer.
Beep,
beep,
beep
Long
beep
Confirmation
beep
Confirmation
beep
Release button
“
B
”
.
* The log data has not been deleted yet.
The newest log data
is shown.
Release button
“
B
”
.
To delete one log data set
* Be sure to keep button
“
B
”
pressed until the confirmation beep sounds. Otherwise, the log data will not be deleted.
* The entire log data can be deleted only after one log data set is deleted.
* The log data in memory can be checked or deleted in both the SPM_LOG and PACE_LOG modes. If any log data set is deleted in one mode, it
cannot be checked in the other, either.
* Before deleting the log data, check that the chronograph is reset.
Deletion of log data stored in memory
・
When the number of measurement data in memory nears the capacity limit (up to 300 data can be stored), the storable number of data can be increased by deleting the log data.
To delete the entire log data
Notes on deletion of log data
