ALPACO ELEGANCE INSTALLATION
Page 3
STEP 3:
FIGURE 3
POSITION PANEL
A. Assemble pedestal and adjust it to the
desired height.
B. Place the panel on a temporary support
device that is 6” (9” if required) tall. Set
the panel into the wall bracket and
unanchored pedestal.
C. Adjust the gap between the panel and
wall bracket.
D. Plumb, level, and fasten the panel to the
wall bracket.
E. Remove the support device.
STEP 4:
FIGURE 4
PILASTER PREPARATION
A.
Note that each pilaster is labeled on its front and can be
matched to the layout based on that label.
Align the U-brackets
in position on rear of pilasters. Refer to layout drawings and make
sure U-brackets are in alignment with wall brackets.
B. Mark U-bracket holes using the wall brackets as templates. Drill
0.165” diameter x 7/16” deep holes for U-bracket fasteners (a #19
drill bit and drill bit stop are recommended for this).
Correct hole
diameter and depth is critical.
C. Fasten U-brackets to pilaster.
Note that the pilaster is pre-drilled
for headrail clips, and these headrail clips should be on top of
the pilaster and facing outside the compartment before
fastening.
160 Tower Drive
, Burr Ridge,
IL 6052
7
Phone: (708) 442-6800 Fax: (708) 442-7439
www.asi-accuratepartitions.com
