PIPE SAW 400SA
17
［ Information ］
※ Oil may ooze out depending on the using
condition of Air Motor of the machine.
This is one of the characteristics of a lubricating
air motor and not a defect.
⑩ After finishing the operation, close Ball Valve, turn Handle clockwise, and stop Air Compressor.
⑪ Wait a short time after cutting, remove the components in the order of
[Guide plate] → [Saw blade] → [Main body] → [Vise]
◆ Be sure to use the threading oil white（No.STO14）as the cutting oil.
Do not use other cutting oil．
◆ Cutting oil contacting the skin may cause inflammation.
Wear protective gloves when handling the cutting oil. In case it contacts your hands，completely
wash it off with water and soap.
◆ Wipe off the scattered cutting oil after cutting with oil.
The floor may be slippery by cutting oil, causing a fall down.
◆ Do not inhale oil mist or vapor of the cutting oil．It cause nausea．
If inhaled accidentally, move to a place where fresh air prevails. Cover the body to keep warm, lie
quietly and consult a doctor．
◆ Do not handle or use the cutting oil near a fire.
⑧ Use the cutting oil depending on the material of pipe.
⑨ The extent of oblique cut will be reduced by using
a blade and Guide Plate for 200A in case of cutting
pipes less than 6".
⑦ Rotate the operating handle counterclockwise and
cut the pipe slowly.
Rotate the handle with the force that does not
decrease the stroke speed．
When the motor gets a heavy load during the
operation, the motor automatically stops.
If a motor stops, rotate the operating handle to the
clockwise, and, please give cutting speed.
Operating handle
Rotate slowly
7
Material of pipe
Cutting oil（use or not）
Steel pipe
Use
Stainless steel pipe
Cast Iron（Ductile）pipe
Not use
mortar lining casting pipe
Resin pipe
CAUTION