LEVEL 8 Owner's Manual v 2.21 CE ©2003 ARX®
LEVEL 8 Owner's Manual v 2.1 CE ©2003 ARX®
2
7
LEVEL 8 Specifications
Mode of operation
8:8 Level Optimizer / Balancer
Input Impedance
100K Ohms Unbalanced
Output Impedance
300 Ohms Balanced
Input Headroom
+21dB
Output Level (max)
+26dB
Signal/Noise
(@ unity gain)
-94dB unweighted
-100dB A weighted
Gain
0dB Unity, Mode switch OUT, or
14 dB, Mode switch IN
(–10dB to +4dB level matching)
Dynamic Range
120dB
Output Impedance
300 Ohms Balanced
150 Ohms Unbalanced
Frequency Response
10Hz-20 KHz ±0.25dB
Distortion
(@ unity gain)
.0025% THD, 0dB 1 KHz
Input Connector Type
¼”Jack
Output Connector Type
Male XLR, wired Pin 1 Gnd, Pin 2 + Hot,
Pin 3 – Cold
Power Requirements
100–120 V/ 220/240 V AC
50 - 60 Hz 8 Watts (8 VA)
Size
19”W x 6”D x 1¾”H, 482 x 155 x 44mm
Weight
2.2 Kg (5 lbs)
This symbol indicates that a Slow Blow fuse is used in this equipment.
Replace with same type and value only
This symbol is intended to alert you to the presence of uninsulated danger-
ous voltage within the product's enclosure that may be of sufficient magni-
tude to constitute a risk of electric shock.
This symbol is intended to alert you to the presence of important operating
instructions contained in this owner's manual
WARNING SYMBOLS USED ON THIS EQUIPMENT
IMPORTANT
- PLEASE READ THIS FIRST
This is a dual voltage unit. It is essential that you check that the voltage on the
fuseholder cover below the AC connector on the rear of the chassis is set correctly
before connecting it to AC power.
To change, pull fuseholder out and rotate 180
o
, then push in again. Do not insert
power cable into unit until voltage has been correctly set. Do not plug power cable into
AC power until voltage has been correctly set
THIS IS SET FOR
100 V AC TO 120 V
AC OPERATION
THIS IS SET FOR
220 V AC TO 240 V
AC OPERATION
Complies with 89/336/EEC EMC Directive,
amended by 92/31/EEC and 93/68/EEC and
meets the following standards:EN 55013 :
1990, Sections 3.2 and 3.5 EN 55020 : 1988,
Sections 4.3, 5.4, 6.2, 7.0, 8.0.
Complies with Australian Standard AS/N25
1053
