5.2.2. Double Channel Preamp Section and Output
The preamp section in the Double Channel configuration, besides having doubled the
controls we saw in the Single Channel configuration, also has some extra buttons to select
the special working modes we have available with this configuration.
It is located on the right side of the control panel, as was the case with the Single Channel.
On top, we have two VU meters, one for each channel. Remember that we can calibrate the
VU meters by clicking on the corresponding window/button in the right side of the lower
toolbar section of User Interface.
Right below the VU meters, we have the Input Gain knobs. Again, we now have two, one
for each channel. These knobs control the saturation level (drive) added to the sound. Their
values go from -60dB to -20dB with the default position in -60dB. When we increase this
value, we increase the saturation level.
Below the Input Gain knobs, we have the Phase Invert buttons, which default to Off. Right
below these, we have another pair of buttons, the EQ switches. These allow you to switch
the EQ section On and Off. Default position is On, of course.
So far, everything is the same as it was in the Single Channel, except that we have pairs for
all of it.
TridA Double Channel preamp section and
the global Phase and EQ switches
TridA Double Channel Output Trim knobs and the switches
to control the Double Channel behavior (Stereo Link and
Stereo Mode)
Arturia - User Manual TriA-Pre - TridA-Pre CONTROL PANEL
33
Summary of Contents for TridA-Pre
Page 1: ...USER MANUAL...
