___________________________________________________________________________________
ARTURIA – JUPITER-8V – MANUAL - EN
27
of dynamic modulations of other parameters such as the cutoff frequency of the VCF or on the
width of the square waveform of the VCO's.
It enables you to affect up to 3 simultaneous parameters.
The step sequencer
In this chapter we will see how to create a simple melodic sequence.
Click on the «SEQUENCER/ GALAXY » tab, and then click on the « SEQUENCER » tab to bring
up the interface.
Click on the “SEQUENCER” button
Connect the frequency of VCO1 to the first modulation output by clicking the « Q » button
to activate the quantize factor by half-tones for the frequency values.
Click on the “Q” button
Set the "Amt" knob ( "Amount" ) to let it blend in to your likings.
Do the same for VCO2
to start the sequencer, click on the button "play". At this point all the steps have the same
frequency value. (This value corresponds to a C3 note )
Set the value of each step by clicking and dragging the 16 bars up or down to create your
Melody.