20
Input connectors
MICROPHONE LENGTH SETTING PROCEDURE
DynamicTalk is designed to work with microphones of different lengths. Two
signs to identify an incorrect setup of the microphone length are:
- The microphone do not goes down completely.
- The microphone goes down too slowly and gets stuck inside.
The microphone length can be adjusted using the Monitor Configurator
Tool, but there is also a quick procedure that doesn’t require the use of a
PC or cable:
1. Disconnect the Power connector
2. Set switch 5 to ON position
3. Set the length of the microphone in the rotatory switch,
in cm. For instance, if the microphone is 40cm, set the
rotatory switch as: tens=4, unit=0
4. Connect to Power. There will be a 5 beep sound
5. Disconnect Power
6. Set switch 5 to OFF position
7. Set the AHnet address in the rotatory switch, the default
setting is address 01 (tens=0, units=1).
8. Connect the Power connector
