LIST OF FIGURES
Figure 2 – 1
Layout of controls, indicators, and receptacles on the front panel..................2-2
Figure 2 – 2
Controls for setting and recalling presets........................................................2-4
Figure 2 – 3
Controls for the Cut and Blend modes............................................................2-5
Figure 2 – 4
Controls for the Coag mode ............................................................................2-6
Figure 2 – 5
Controls for the Bipolar mode .........................................................................2-7
Figure 2 – 6
Indicators for power, return electrodes, and footswitch control.......................2-8
Figure 2 – 7
Location of the unit power switch and front panel receptacles .......................2-9
Figure 2 – 8
Layout of connectors and controls on the rear panel....................................2-10
Figure 5 – 1
Fuse holder......................................................................................................5-2
Figure A – 1
Output power vs impedance for Cut I mode ...................................................A-5
Figure A – 2
Output power vs impedance for Cut II mode ..................................................A-5
Figure A – 3
Output power versus impedance for Blend mode, set at Minimum................A-6
Figure A – 4
Output power versus impedance for Blend mode, set at Maximum...............A-6
Figure A – 5
Output power vs impedance for Pinpoint mode..............................................A-7
Figure A – 6
Output power vs impedance for Spray mode .................................................A-7
Figure A – 7
Output power vs impedance for Bipolar mode ...............................................A-8
vi
Arthrex, Inc.