Hardware Preparation and Installation
ATCA-7365-CE Installation and Use (6806800L73N
)
52
2.5
Installing the Blade Accessories
The following additional components are available for the blade:
DIMM memory modules
PMEM (persistent memory) module
SATA module
USB flash module
Rear transition modules
SW3-2
SW3-2 controls boot flash selection if SW3-1 is set to ON
OFF: Boot from “Default Boot Flash” device (default)
ON: Boot from “Recovery Boot Flash” device
SW3-3
Enable faceplate (Front board and RTM) reset push button
OFF: Reset push button enabled (default)
ON: Reset push button disabled
SW3-4
ICH10 TCO Timer system reboot feature
OFF: ICH10 TCO Timer system reboot feature enabled (default)
ON: ICH10 will disable the TCO Timer system reboot feature
SW4-1
Reserved
OFF: Default
SW4-2
ICH10 TCO Timer system reboot feature
OFF: ICH10 TCO Timer system reboot feature enabled (default)
ON: system is strapped to the “No Reboot” mode (ICH10 will disable the TCO Timer
system reboot feature).
SW4-3 and
SW4-4
Load BIOS default settings
OFF, OFF: Normal operation
OFF, ON: Load BIOS default from IPMI Boot Parameter DEFAULT area
ON, OFF: Reserved
ON, ON: Status Codes to COM
Table 2-4 Switch Settings (continued)
Switch
Description
Summary of Contents for ATCA-7365-CE
